User Manual

RPC/RP Manual RP Installation

19June2000 WLL-RPC/RP-IN/UM-1.0

3.3.2 Site Selection

For indoor RP installation, select a site that satisfies the following requirements:

• Less than 3 meters from the RP antenna

• Not in direct sunlight or near a heat source such as a radiator

• Free from excessive humidity; not more that 95% non-condensing

• Free from excesses of heat or cold, not lower than -10°C nor higher than

+50°C

F NOTE: If more than 3 meters , consult a qualified field engineer.

3.3.3 Indoor RP Installation

Follow the steps below to install an indoor RP:

1. Carefully unpack the indoor RP and make sure it is in good condition.

2. Attach the mounting plate to a wall with 2 screws as shown in Figure 3-9.

Figure 3-9: Indoor RP Mounting Plate