User Manual

RPC/RP Manual RP Installation

19June2000 WLL-RPC/RP-IN/UM-1.0

Figure 3-4: Accommodated Subscribers per RP in Group and Non-group Control

The recommended installation design for RPs is as follows:

• A zone of sparse subscribers should be covered by non-group controlled

RPs.

• A zone of dense subscribes should be covered by group-controlled RPs.

The number of accommodated subscribers is the greatest when all of the RPs

connected to an RPC are configured in the group control mode. In this case (with

4 RPs in each group), the number of service zones is eight (32÷4), and the

maximum number of subscribers is 1,056 (132x8). Each Group Control zone

supplies 15 traffic channels. Eight zones require 120 channels (15x8) provided by

4 E1 lines with 30 channels each.

3.1.2 Cell Overlap

Maximum service results are achieved when the RP coverage area is strategically

installed in a Cell Overlap Capacity.