User Manual

RPC/RP Configuration RPC/RP Manual

WLL-RPC/RP-IN/UM-1.0 19June2000

Upon the restoration and restart of the failed master RPC, the first slave RPC

needs to be blocked and re-synchronized in order to regain synchronization. This

process is implemented through Netman.

1. From the Maintenance pull-down menu, select Unit Control, and then RPC

Sync. The RPC Synchronization window opens, as shown in the figure

below.

Figure 4-23: RPC Synchronization Window

2. Click the RPC blockage radio button to block the slave RPCs. Click OK to

execute the command. Verify the blockage by checking the RPC Status

window and the Self Message window.

3. Return to the RPC Synchronization window and click the RPC

synchronization radio button. Click OK to synchronize the slave RPCs.

After the command is implemented, the slave RPCs become synchronous in

operation to the upstream RPCs.

4.2.3.6 Online Trace

The Online Trace feature is used to check the time slot status of the RPs.

1. From the Configuration main menu, select Unit Control, and then Online

Trace. This opens the Select Online Trace window, as illustrated in the

figure below.