User Manual

RPC/RP Manual RPC/RP Configuration

19June2000 WLL-RPC/RP-IN/UM-1.0

the units controlled by the RPC. No new calls will be accepted and all the

calls in progress are allowed to complete and then dropped.

3. When the action is implemented, the system displays a message in the Self

Message window, and the Status View window will also show the Blockade

result, as illustrated in the figure below. Use the window to verify the result.

Figure 4-17: Self Message and Status View window for Blockade

F NOTE: If an RPC or all RPs are blocked, calls cannot be made.

4. Zero “o” in the Blockade Maint column means the unit is blocked, and dash “-

” means the unit is unblocked. The Status and the Self Messages windows

both indicate that RP#1 and RP#2 are blocked.

5. There are two ways to access the Status View window. One is to click Status

and then the relevant options: RPC, RPs, RP-I/F Board, E1 Signal, Node-I/F

Board, Air Channel, or TimeSlot Status. The other is to click the target item

on the left frame of the RPC window. In either case the Status View window

opens on the right frame. Of course, one can always access the window by

clicking the relevant toolbar.