User Manual

RPC/RP Manual RPC/RP Configuration
19June2000 WLL-RPC/RP-IN/UM-1.0
4-
45
the old loaded operation data. For the RPC to run based on the newly loaded
operation data, the RPC needs to be reset.
1. From the Configuration main menu, click Service Data, and then Write
Data. This opens the Write System Service Data window, as shown in the
figure below.
Figure 4-50: Write System Service Data Window
2. Click the Write radio button and then click OK. The Select File for Writing
Service Data window appears, as illustrated in the figure below.
Figure 4-51: Select File for Writing Service Data Window
3. Select the target file with either a .dat or a .eep extension and click Open.
The system overwrites the service data on both the SDMs of the RPC.