User Manual

RPC/RP Manual RPC/RP Configuration

19June2000 WLL-RPC/RP-IN/UM-1.0

1. From the Maintenance pull-down menu, select Program Download, and then

Program Switch. The Program Switch window appears, as shown in the

figure below.

Figure 4-44: Program Switch Window

2. This window is exactly the same as the previous one. Make a selection in the

Operation Switch Timing block. If you click the Specified switch date

radio button, specify the date and time for the new program to go into

operation. Click OK to accept the setting or Cancel to stop the transaction.

After switching at the specified time, RPC runs based on the SBY PDM and

each PDM status is switched.

4.3.3 Data Load

Operation data can be loaded and put into operation by selecting the Service Data

options. Use the procedure in this section to load the operation data to the SBY

SDM and to specify the time to switch to the new data.

1. From the Configuration pull-down menu, select Service Data, then Data

Download, and then Data load. This opens the File for Data Download

window, as illustrated in the figure below.