User Manual

RPC/RP Configuration RPC/RP Manual
WLL-RPC/RP-IN/UM-1.0 19June2000
4-
24
Figure 4-27: RPs Operation Status View window
Field Name Description
Group The ID number of the group to which the RP belongs
Master The sign * indicates the master RP.
RP# Radio port ID number
Inst. Installation status. “Inst.” Indicates that the RP has been installed.
Power The voltage of power. Usually it is 10mW. There are two power supply
state:
Pha. - supplied from RPC (Phantom)
Loc. - supplied from RP power unit (Local)
Trans. Transmission state for control channel. Group control maximizes the
number of channels available for traffic by allowing one control channel to
control up to 8 RPs.
Layout Configuration of the control channel: completed/incompleted.
Mainte Maintenance state:
o indicates the maintenance is configurated.
- indicates the maintenance is not configured.
Blockade Blockage state:
o indicates the unit is blocked.
- indicates the unit is not blocked.
Auto Automatically blocked by automatic reconfiguration processing
Maint Blocked manually by HOST or Netman
Fault Cut off from operation system due to unit trouble
Warning Warning state:
o indicates the existence of a warning.
- indicates no warning exits.
RP RP interface detects RP suspension.
Trans. RP transmission power is incorrect.
Syn RP synchronization is lost.
I/F RP interface detects cut-off from RP.
Table 4-3: RP Status Window Field Description
2. This window displays the operational status for all the RPs controlled by the
target RPC. Click the Update button to retrieve the current RP status. The