User Manual

RPC/RP Manual RPC/RP Configuration

19June2000 WLL-RPC/RP-IN/UM-1.0

Field Name Description

ACT The active SDM or PDM system for RPC running

Program System PDM system. There are two plane memory areas for the

program data: N and E. Any one can be active or standby.

SDM System SDM system. There are two plane memory areas for the

operation data: N and E. Any one can be active or standby.

Update Retrieve the latest mode information and display the time

when the mode information is updated.

Mode Display mode information for the current RPC, such as,

master/slave status, synchronization status, transmission

status, etc. The following rows describe various mode

displays.

Mode Display Description

Master Master RPC - the RPC that generates the air frame

synchronization signal.

Slave Slave RPC - the RPC that receives the air frame

synchronization signal.

Sync. signal Trans. The RPC transmits the synchronization signal to the slave

RPC or the next slave RPC.

Sync. signal Stop The RPC doesn’t transmit the synchronization signal to the

slave RPC or the next slave RPC.

Sync. between RPC Sync. The slave RPC synchronizes to the upstream RPC.

Sync. between RPC Async. The slave RPC doesn’t synchronize to the upstream RPC.

Table 4-2: RPC Status Window Field Description

2. This window is for view only. In this instance, there is no special meaning for

N or E. It simply displays which system is active. Refer to Section 4.3 for the

description of the N and E systems.

4.2.4.2 RP Status

Use the RP Status option to monitor the operation status of individual RPs and to

verify any change made to the RP configuration and setting.

1. To access the RP Status window, click Status, then Status, and then RPs.

Another way to display the window is to click the RP Status button. The RP

status is displayed on the Status View window, as shown in the figure below.