User Manual

Fixed Subscriber Unit Installation Manual Installation Instructions
Release 1.00 10/03/97
Airstar-Wireless Local Loop
4-31
7. If wall mounting is desired, locate a position on the wall for
the FSU. Mark the screws’ locations using the enclosed
mounting template. Mount the main unit on the wall using
the supplied two screws. Refer to Figure 4-17.
84 mm
Figure 4-17 : Wall Mounting
8. If wall mounting is not desired, be sure to affix the Antenna
Cable to a stable surface such as a wall, a floor, or a table to
insure that the FSU does not move by force of a loose
antenna cable.
4.6 Antenna Orientation Adjustment
If it is necessary to adjust the position of the antenna, follow the steps below
to orient the antenna for better reception :
1. Loosen the bolts fastening the antenna to the bracket.
2. Connect the PHS Signal Analyzer to the antenna. It may be
necessary to use the coaxial cable adapter (TNC-J/SMA-J).
3. Turn on the PHS Signal Analyzer’s power and turn the
antenna to the direction with the maximum RSS level.
4. Tighten the fastening bolts.