User Manual

Fixed Subscriber Unit Installation Manual Installation Instructions
Release 1.00 10/03/97
Airstar-Wireless Local Loop
4-19
4.3 Coaxial Cable Installation
Once the locations for the antenna and the main unit have been determined,
use the procedures in this section to install the cable.
1. Measure and cut a length of cable to fit between the main
unit and the antenna.
2. Run the cable between the main unit and the antenna.
3. Using the cable stripper, strip both ends of the coaxial
cable. Refer to the figure below for exact dimensions to
strip.
6mm
6mm
3mm
Figure 4-5 : Stripped Coaxial Cable
4. Carefully mount the coaxial cable terminals onto the cable
ends.
5. Affix the cable terminals using the crimper.