User Manual

3-26 Setting Up Your Phone UT618 User Manual
3. If you want to end calculation, press
to go back to standby mode.
• ·Press
to go back to “Special” menu.
)
))
) Note:
• You can use this result to do the next calculation.
• If the calculation is over 10 digitals or it is against algorithm, the phone will
sound warning beep and “ERROR” will be displayed.
• When you calculate, if there is an incoming call and you answer it then the
calculation data will be lost.
3.19 LDS (needs network support)
• If you set LDS on and use “Air Info”, the location of the phone will be
recorded in MiMi center. Therefore, you can get your current surrounding
information.
• This function can be used under Public/Group mode. When any three digits
of a telephone number are dialed, the location information will be sent to
MiMi center.
• Its default setting is “OFF”.
1. Press , to display “LDS” ON/OFF icon.
2. Press to switch on/off.
• If LDS is turned on,
icon will be displayed on the main display.
3.20 LTS (needs network support)
• Setting LTS “ON” allows you to trace the phone.
• In order to protect the user’s privacy, it required password validation for
using “LTS”. This password is an independent password, which is different
from the phone password.
• For more detailed information, please contact your local service provider.
• Its default setting is “OFF”
• The default password for LTS is “9999”.
3.20.1 Setting LTS
1. Press , to display “LTS” menu.
2. Press to select “1 LTS Setting” enter the password.