User Manual

WiFi Settings -> WiFi Config
71
set the WEP key. After accessing this option, observe the following
operations:
1. Select Auth Method, and then select the authentication method:
Open Key or Shared Key.
2. Select 64 bit or 128 bit according to the AP’s WEP key setting. Enter
the WEP key that the AP used, and press the left soft key
(Save).
- If 64 bit is selected, ensure that the WEP key consists of five ASCII
characters or ten hexadecimal characters
- If 128 bit is selected, ensure that the WEP key consists of 13 ASCII
characters or 26 hexadecimal characters
3. Select WEP Key Index. Enter the WEP key index (1-4), and then
press the left soft key (Save).
œ Note: The WEP key setting may be different due to AP settings.
œ Note: If an AP supports only a fixed hexadecimal WEP key, you
should enter the same WEP key in the phone.
œ Note: If an AP supports both ASCII and hexadecimal WEP keys, you
can enter either the ACSII WEP key or the hexadecimal WEP key in
the phone.
WPA-PSK Info
If the AP profile’s security mode is set to WPA-PSK, select this option to
set the WPA-PSK key.
After accessing this option, enter the WPA-PSK key and press the left soft
key (Save) to complete the operation.
l Ensure that the WPA-PSK key consists of 8-63 ASCII characters or 64
hexadecimal characters
Activate