Instructions / Assembly

Pg 5 of 7
5.
Mount the rod approximately 78” above the
floor. This will make the curtain fall 8” above
the floor. If this is not acceptable, adjust the
height to the desired location. Draw a light
horizontal line at the desired location at both
ends of the tub. The rod will be installed at
that height and centered over the tub rim.
Hold the shower curtain rod assembly in
desired location. Turn the end caps (C) into
the upright position with the screw hole
closest to the wall in the “neck” of the end-
cap is on top, as shown. Line up the bottom
of each end cap (C) with the line you drew.
Mark the locations for the mounting screws
(F) on the wall through the holes.
C
78”
78”
Screw hole closest to the wall in the “neck” of
the endcap is on top, as shown.
Mark the locations
of the screw holes