Manualshelf

Instructions / Assembly

ManualsBrandsUtopia 4niture ManualsFire Pit TablesWarren 28 in. Black Metal Slat Top Gas Fire Pit Table
12345678910
MASTER CONTRACT: 263865
REPORT: 70030918
PROJECT: 80056731
Page No: 5
Date Issued: September 30, 2020
DQD 507.10 Rev 2020-07-02 © 2020 CSA Group. All rights reserved.
The manufacturer is required to apply the following markings:
• Products shall be marked with the markings specified by the particular product standard.
• Products certified for Canada shall have all Caution and Warning markings in both English and French.
Additional bilingual markings not covered by the product standard(s) may be required by the Authorities Having
Jurisdiction. It is the responsibility of the manufacturer to provide and apply these additional markings, where
applicable, in accordance with the requirements of those authorities.
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and
US (indicating that products have been manufactured to the requirements of both Canadian and U.S. Standards) or
with adjacent indicator 'US' for US only or without either indicator for Canada only.
All markings in compliance with the applicable requirements are found on figure number 450 through 461, 660
thru 664, 1076 to 1078, 1082, 1096, 1100, 1114, 1138 to 1143 and 1190.
Nameplate adhesive label material approval information:
The specifications of the marking system as follows: Rating plate is Class IIIA-2 by Guangdong Tianyue
Printing Tech Co., Ltd. With the maximum temperature 125C (257F) when affixed to aluminum, galvanized steel,
stainless steel, acrylic paint, epoxy paint and porcelain; or permanent hang tag made by Aluminum alloy, hang
with chain. Content silk-screened on the metal plate, please refer to figure no.39 to 40.
ALTERATIONS
Project 70030918:
• Shorten the hose to a suitable length to avoid hose touching the hot surface. Please refer to figure xx for
detail.
• The installation height of the thermocouple was lowered to 27.5mm, from tip top to the burner pan, of
model G-FTB-51032, and the design of screen was changed, so as to pass the Component temperature test
(thermocouple lead). Please refer to figure no.220 and 225.
Project 70076502 – No alteration required.
Project 70113883 – No alteration required.
Project 70166152 – No alteration required.
Project 70189001
• Polish the sharp edges on heating insulation shield, to comply with section 4.1.4. See construction review
reply for detail.
• Decreased the cylinder the support width from 530mm to 535mm, and the length from 532mm to 535mm,
to avoid the displace of cylinder support. See construction review reply for detail.
• Shortened the length of flexible hose from 450mm to 380mm, and changed the angle of inlet of manual
valve downward, to prevent flexible hose from hot surface. See construction review reply for detail.
• Used certificated label material. See construction review reply for detail.
Project 70190968 – No alternation required.
Project 70207528 – Manual and marking alerted.