Product Manual

- 4 -
Subject To Change Without Notice
FEATURES (See Figure #1)
A. How To Use The “Extended Tongue” Feature
1= Regular Position 2 = Extended Position
The tongue can be installed in two positions. The Extended position will allow the use of the
optional extension / side kit.
How to: Make sure you first properly support the trailer to allow the safe movement of
the tongue forward from below the frame. With the proper size tools, remove the 24mm x
12cm Hex Bolt and Lock Nut at the back of the tongue. Pull the tongue forward until the
holes at the back of the tongue line up with the middle tongue mount bracket. Re-insert the
24mm x 12cm Hex Bolt and Lock Nut and properly re-tighten. Slide the extra 12v wire back
to the tongue after changing the tongue position, making sure the tongue plug is still firmly
connected to the 12v trailer frame plug. The Hitch Pin and L-Bolt do not need to be removed
as the tongue will slide forward or back while this pin is still in position.
B. How To Use The “2 Position Axle”
1= Back Position 2 = Front Position
The UtlityDump™ trailer comes with a 2 position axle design. This feature allows the user to
control how much of the trailers load is distributed to the vehicle. This feature has the benefit
of improved handling under low load conditions and reduced tongue weight under heavy load
conditions. Also the feature allows the trailer to remain or not stay in a tilt / dump position
depending on the position of the axle.
How to: Make sure you first properly support the back of the trailer with blocks then
use a jack on the tongue to lift the trailer securely so that the tires are about an inch of
the ground. Using the correct tools, remove the (4) 19mm x 9cm bolts along with the trailer
fenders. Slide the axle, spring and tire assembly to the desired position. Reinsert the (4)
19mm x 9cm hex bolts through the fender and spring then into the frame channel and secure
with the 21mm lock nuts. You will need to lower the trailer to line up the front hole on the
spring. The back bolt goes under the leaf of the spring to hold it against the frame. Make
sure all parts are properly installed, secured, and tested before you use your trailer.
Note: For general use you may with to leave the axle in a fixed position. In this case the
preferred axle location would be in the forward position. For heavy loads, the axle must be in
the forward position..
C. How To Use The “Tilt / Dump” Feature
1 = Regular Tongue Position 2 = Extended Tongue Position
The UtlityDump™ trailer has a tilt feature to help with loading and unloading of cargo.
How to: First make sure the trailer is attached to the towing vehicle. Remove the front Hitch
Pin and L-Bolt on the tongue, this will allow you to tilt the trailer to the dump position.
CAUTION WHEN TILTING THE TRAILER: The trailer may tilt quickly and
unexpectedly during the loading and unloading process.
Note: Axle is shown in the forward position. In this position the trailer will have a better
tilting angle.