Instructions

PUMP PRIMING & STARTUP (CONTINUED)

FREEZING

CAUTION: Drain the entire system if there is

danger of freezing. A drain plug is provided at the

bottom of the pump case for this purpose. Remove

drain plug then loosen air relief plug. (Fig 47).

Fig 47

PREVENT

PUMP

DAMAGE!

Remove plug

in freezing

weather

Drain Plug

Air Relief Plug

Pipe

Support

Check pipe for sagging

Fig 46

IMPORTANT: If the pump hums instead of

pumping or turns off repeatedly, shut pump off

immediately.

Check voltage. Pump is wired to run on 230V. If the

pump cuts out or stops, you may be attempting to

connect to 115V. See Motor Voltage Change instructions

to change motor voltage to 115V.

IMPORTANT: If the pump fails to prime within five

minutes:

1. Turn power off at the breaker box.

2. Check all pipe connections for leaks. All connections

must be water and air tight in order for pump to

operate.

3. Check suction pipe for any sagging. Support suction

pipe in a straight line to the pump. (Fig. 46)

4. Watch for leaks or a milky color in the discharged

water, which indicates an air leak. Re-prime if

necessary, following steps 1 through 5 under the

PRIMING section.

5. Reset breaker at the breaker box.

CARE AND MAINTENANCE