Use and Care Guide

8
Lowes.com
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The lights do not
come on.
1. The light switch is turned off.
2. 
burned out.
3. The fuse is blown or the circuit
breaker is turned off.
4. Daylight turn-off is in effect.
5. The wiring is incorrect (new
installations).
6. The sensor is not covering the
area adequately.
1. Turn the light switch on.
2. 
3. Replace the fuse or turn on the
circuit breaker.
4. Re-check after dark.
5. Re-check the wiring.
6. Re-aim the sensor to cover desired
area.
The lights come on
during the daylight.
1. The light control may be
installed in a relatively dark
location.
2. The light control is in TEST
mode.
1. Move the light to a brighter location
during the daylight hours.
2. Set the control switch to an ON-
TIME position.
The lights come
on for no apparent
reason.
1. The light control may be
sensing small animals or

2. The range is set too high.
3. The light control is in MANUAL
mode.
1. Reposition the lamp away from the
sensor or nearby objects.
2. Reposition the sensor.
3. Switch to AUTO mode.

and off.
1. Heat or light from the lamps
may be turning the light control
on and off.
2. 
objects may be affecting the
sensor.
3. The light control is in the TEST
mode and warming up.
4. The light may be leaking


1. Reposition the lamps away from the
sensor.
2. Reposition the sensor.
3. Flashing is normal under these
conditions.
4. Make sure the metal lamp protectors
are installed.