Installation Guide

BULB REPLACEMENT INSTRUCTIONS

You may want to periodically clean the fixture using a mild, non-abrasive soap-based cleaner and

soft cotton cloth. Do NOT use solvents, cleaners containing abrasive agents, ammonia, or

surfactants. When cleaning the fixture, make sure you have the power turned off and do not spray

liquid cleaner directly onto the diffuser, bulb, socket, ballast, or wiring.

CARE AND MAINTENANCE

3. Install the new bulb in the same manner you removed the old bulb.

Re-install the grid (E). Restore

power to the fixture.

4. Dispose of the old bulb(s) in accordance with local, state, and/or federal laws.

2. Remove the bulb from the fixture (A) by placing your

thumbs on the metal ends of the bulb. While applying

slight pressure on the bulb, roll the bulb toward you until

the contact pins on the ends of the bulb disengage from

the socket. Pull the bulb straight out from the socket.

Minor problems often can be fixed without the help of an electrician. Before doing any work on the

fixture, shut off power supply at the circuit breaker panel to avoid electrical shock.

TROUBLESHOOTING

Fixture doesn’t light.

Circuit breaker trips

when light is turned on.

1. Power is off.

2. Bad wire connection.

3. Defective bulb(s).

4. Defective wall switch.

1. Crossed wires or power wire

is grounded out.

1. Check circuit breaker or wall switch.

2. Check wire splices.

3. Replace bulb(s).

4. Replace switch.

1. Check wiring connections.

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Lowes.com