Installation Guide
6
TYPICAL JET PUMP INSTALLATION
TYPICAL SUBMERSIBLE PUMP INSTALLATION
Do the following for a submursable pump installation:
1. Complete pump assembly and electrical connections as
specied in pump installation manual. Place tank in desired
location and level it.
2. Thread tank tee into pressure tank so that the two 1/4” holes
in the tee face upward. Thread street tee into front of tank tee.
Figure 3. Tank Tee Threaded into Pressure Tank
3. Thread 3/4” male PVC adapter into the inlet side of tank tee.
Figure 4. 3/4” Adaptor Threaded in Tank Tee
4. Thread pressure relief valve into top of street tee. Thread 1/2”
boiler drain into front of street tee. Cut and cement as many
sections and couplings of PVC pipe needed to connect 3/4”
male PVC adapter to pump discharge.
Figure 5. Pressure Relief Valve Threaded into Street Tee
The complete installation should look like Figure 6 shown below:
Figure 6. Submersible Pump With Vertical Tank
Do the following to forl a typical jet pump installation:
1. Thread 10” X 1” nipple into pressure tank. Thread tank cross
into nipple so that the two 1/4” holes in tank cross face upward.
Thread street tee into front of tank cross. Thread pressure
relief valve into top of street tee and thread 3/4” boiler drain
into front of street tee.
Figure 7. Street Tee Fittings
2. Thread 1” male PVC adapter into the inlet side of tank cross.
Figure 8. PVC Adapter