Installation Guide

8. Install (2) 17-watt T8/CCT-3000 up tp

CCT-4100K/10,000 hour/F17T8 fluorescent bulbs (not

included). Do not use any other wattage of linear

fluorescent bulb. Install the bulb into the bulb sockets (B)

by aligning the pins of the bulb with the slot in the bulb

sockets (B) (Fig. 8). Using your thumbs and forefinger,

press the metal ends of the bulb, and roll the bulb forward

until it rotates 90 degrees inside the bulb socket (B),

making contact between the bulb pins and the bulb socket

(B) contacts. Repeat for each bulb.

BULB REPLACEMENT INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

7. CEILING JOIST MOUNTING:

While holding the fixture

(A) in line with the pilot holes, screw the wood screws (BB)

into the wooden studs (Fig. 7). Tighten until the fixture (A)

has been secured to the mounting surface.

DRYWALL MOUNTING: For mounting into drywall, hold

your fixture (A) in line with the drywall anchors (CC) that

were installed in step 2, and screw all wood screws (CC)

into the drywall anchors (CC). Tighten until the fixture has

been secured to the mounting surface.

Hardware Used

Wood Screw x 2

While holding the diffuser (C) with one hand,

maneuver the diffuser (C) into one side of the fixture (A)

so the diffuser (C) rests on the end cap (Fig. 9). Next,

slide the diffuser (C) into the other end cap until the

diffuser (C) rests evenly between the two end caps.

Restore power to the fixture.

When bulb replacement is necessary, you must replace the bulb with a 17-watt, 120-volt/CCT-3000 up to

CCT-4100K/10,000 hour/F17T8 fluorescent bulb.

Before replacing the bulb, shut off power to the fixture at the circuit breaker or fuse panel. Allow

sufficient time for fixture and bulb to cool.

Remove the diffuser (C) by pushing it into one of the

end caps (Fig. 1). While holding the diffuser (C) steady

with one hand, pivot the diffuser (C) down and out of

the fixture (A). Then remove the diffuser (C) to expose

the bulbs.