Installation Guide

12
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The fan seems louder
than it should
CFM too great
Be sure the CFM rating on the fan matches
the size of your room
Damper not working properly or damaged
Check damper to ensure it is opening and
closing properly. If the damper has become
damaged, please call Customer Service
Bend in duct too close to fan discharge
Be sure you do not have any sharp bends in
duct closer than 18 in. to the fan discharge
Fan discharge reduced to t smaller duct
Use recommended size ducting to reduce fan
noise
Fan housing not securely attached
Be sure the fan is securely attached
to your ceiling joists
The fan is not
clearing the room
Insufcient intake airow within room
Be sure a door or window is slightly ajar or
opened to allow airow. The fan is not able
to draw air out of the room without enough
airow to draw from
Insufcient CFM
Be sure the CFM rating on the fan matches the
requirements for your room size
NOTE: Using a tissue is not an accurate
method for determining if the fan is operating
properly. If the fan clears steam from the room
within approximately 15 minutes of completing
your shower, then the fan is operating properly
CARE AND MAINTENANCE
WARNING: Disconnect power supply before servicing. See SAFETY INFORMATION before proceeding.
Routine maintenance should be done at least once a year.
• Wash grille with mild soap and water, dry with a cloth.
• Remove excess dirt and dust from the fan housing with a vacuum cleaner.
• Do not use solvents, thinner or harsh chemicals for cleaning the fan.
• Do not allow water to enter the motor.
• Do not immerse resin parts in water over 140º F.
HUMIDITY SENSING OPERATION
3. Fan Off:
Move the wall on/off switch to the “OFF” position.
3