Installation Guide

4 in. duct

Ceiling

Duct tape

or clamp

NEW CONSTRUCTION ASSEMBLY INSTRUCTIONS

4. Mount the fan housing (A) to the joist or stud using

wood screws (4.1) (not included) where indicated.

5. Pull the house wires through the wire box cover hole.

Using a quick connector, secure 120 V AC house wiring

from the wall switch to the fan as shown in the wiring

diagram on page 5. 14 AWG is the smallest conductor

that should be used for branch-circuit wiring.

Carefully push the connected wires back into the

wiring box housing. Reattach the wiring box cover.

CAUTION: If the electrical wires do not match the

colors listed, you must determine what each house

wire represents before connecting. You may need to

consult an electrical contractor to determine safely.

6. Install a circular 4 in. duct (6.1) (not included) and

secure it with duct tape or clamps (neither included).

Finish ceiling work. The ceiling hole should be aligned

with the edge of the fan housing (A).

Joist or

wall stud

4.1

6.1