Installation Guide

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS

3. Remove the three screws (3.1) that hold the motor

assembly (3.2) in place. Remove the fan motor

assembly (3.2) from the fan housing (A). Unplug the

fan power unit (3.3).

4. Remove the wiring box cover (4.1) from the fan

housing (A). Remove the wiring knockout (4.2) from

the wiring box cover (4.1) with a athead screwdriver

(not included).

5. Pull the house wires through the wire box cover hole.

Using a quick connector, secure 120 V AC house wiring

from the wall switch to the fan as shown in the wiring

diagram on page 5. 14 AWG is the smallest conductor

that should be used for branch-circuit wiring.

Carefully push the connected wires back into the wiring

box housing. Reattach the wiring box cover.

CAUTION: If the electrical wires do not match the

colors listed, you must determine what each house wire

represents before connecting. You may need to consult

an electrical contractor to determine safely.

3.1

3.2

4.1

4.2

3.3