Installation Guide

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS

9. Plug in LED panel (B) into the fan housing (A).

Plug in wire connectors (two hole and four hole) from fan

motor into fan housing.

LED

connector

holes

10. Secure the LED panel (B) to the fan housing (A) using

4 long machine screws (BB) and metal washers (DD).

Hardware Used

Long machine screw

x 4

Metal washer

x 4

11. Choose which rim (C) nish suits your room. Lay glass

globe (D) into chosen rim (C).

12. Line up the three notches around the outside of the LED

panel (B) with the three clips on the rim (C). Gently push

up the rim (C) and glass globe (D) as far as possible until

it stops.

Notch

Clip

13. Rotate the rim (C) until it hits the stop and cannot be

rotated any further. Slowly pull hands away and glass

globe (D) and rim (C) will be attached to the fan housing

(A).