Use and Care Guide

4



ASSEMBLY INSTRUCTIONS

DANGER: Fixture must be connected to a 120 Volt, 60 Hz

power source.

1. Turn OFF all power to circuit at main circuit breaker or fuse

box.

CAUTION: DO NOT rely on wall switch alone to turn off power.

2. Select a location on a flat, wooden wall and about 10 feet

(3 m) high. The wood should be at least one inch (25 mm)

thick to safely secure the fixture.

The fixture (A) can be mounted with the three lag screws (AA)

and washers (BB). Using the fixture (A) as a mounting template,

mark three mounting holes. It is recommended to drill 3/16 in.

(4.7 mm) pilot holes for the lag screws. Install the bottom

two lag screws (AA) with washers (BB) first. Screw in the lag

screws (AA) so that there is about 3/8 in. (9.5 mm) of space

under the washers (BB). Place fixture housing assembly (A) on

these two lag screws (AA) and then install the top lag screw

(AA) and washer (BB). Tighten the top lag screw (AA) first, then

tighten the bottom two lag screws (AA).

3. Detach the cover plate found on the fixture housing assembly

(A) by removing the preassembled screws, washers and nuts.



Hardware Used

Lag Screw x 3



Washer x 3

