Warranty Guide

10
The light stays
ON:
The motion sensor may be picking
up a heat source like an air vent,
dryer vent, or brightly painted,
heat-reflective surface.
Reposition the motion sensor or
remove such heat source.
The light comes
on during the day:
The TIME switch is in the TEST
position.
Set the TIME to the 1 min., 3 min., or
10 min. settings.
The motion sensor may be installed
in a relatively dark location.
Relocate the fixture.
The light flashes:
The TIME switch is in the TEST
position.
Set the TIME to the 1 min., 3 min., or
10 min.
CARE AND MAINTENANCE
This LED motion-activated light provides maintenance-free service with no bulbs to change.
To clean, turn OFF all power to circuit and clean surfaces with a mild, non-abrasive cleaner.
CAUTION: Turn OFF all power to circuit at main circuit breaker or fuse box. DO NOT rely on
wall switch alone to turn off power.
To make sure the fixture functions properly, always keep the wall switch in the “ON” position
(including the daytime).
WARRANTY
FIVE-YEAR LIMITED WARRANTY
If this product fails due to a defect in materials or workmanship within five (5) years from the date of
purchase, return it along with proof of date of purchase and it will be replaced with the same or
comparable model free of charge.
This warranty is void if damage or defect has resulted from accident, abuse, misuse or faulty repair.
This warranty gives you specific legal rights and you may have other rights that vary from state to
state.
IN NO EVENT WILL LIABILITY EXTEND TO ANY CONSEQUENTIAL, SPECIAL, INCIDENTAL
OR INDIRECT DAMAGES OF ANY KIND ARISING OUT OF THE USE OR MISUSE OF THIS
PRODUCT. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE EXCLUSION OR LIMITATION
MAY NOT APPLY TO YOU.