Operating Guide

TROUBLESHOOTING
Problem Possible Cause Corrective Action
Pump will not
prime or retain
prime after
operating.
1. Pump won’t prime. 1. See priming instructions on page 6.
2. Suction lift too high. 2. Move pump closer to water source.
3. Hose kinked. 3. Straighten hose.
4. Hose fitting not tight on inlet. 4. Tighten fitting.
5. Air leak in suction hose. 5. Repair or replace hose.
Pump runs
but no water is
discharged.
1. Hose kinked. 1. Straighten hose.
2. Pump is not primed. 2. See priming instructions on page 6.
3. Defective impeller. 3. Replace impeller.
4. Suction lift too high. 4. Move pump closer to water source.
5. Discharge height too great. 5. Reduce discharge height.
6. Clogged inlet. 6. Clean inlet.
Motor runs too
hot.
1. Voltage incorrect. 1. Connect to 115 volt outlet.
2. Restricted discharge hose. 2. Increase hose diameter to 3/4 in.
3. Impeller damaged. 3. Replace impeller.
4. Plugged or kinked discharge. 4. Clean and straighten hose.
5. Insufficient air flow on motor. 5. Make sure ample fresh air is available
at the motor.
Flow rate is low. 1. Hose kinked. 1. Straighten hose.
2. Clogged impeller. 2. Clear obstruction.
3. Worn impeller. 3. Replace impeller.
4. Excessive length of hose. 4. Reduce length of inlet and outlet hose.
Pump will not
run.
1. No power. 1. Verify that unit is plugged into 115 volt
outlet.
2. Impeller jammed. 2. Clean pump cavity and impeller.
3. Motor overheated. 3. Motor has automatic thermal protector.
Wait fifteen minutes for motor to cool.
WARRANTY
This product is warranted for one year from the date of purchase or two years from the date of
manufacture, whichever occurs rst. Subject to the conditions hereinafter set forth, the manufacturer
will repair or replace to the original consumer, any portion of the product which proves defective due
to defective materials or workmanship. This warranty does not cover replacement parts for failure
due to normal wear and tear. To obtain warranty service, contact the retailer from whom the product
was purchased. The manufacturer retains the sole right and option to determine whether to repair or
replace defective equipment, parts or components. Damage due to conditions beyond the control of
the manufacturer is not covered by this warranty. For warranty questions or service, call
1-866-994-4148.
THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions resulting from failure to properly
install, operate or maintain the unit in accordance with printed instructions provided; (b) to failures
resulting from abuse, accident or negligence; (c) to normal maintenance services and the parts
used in connection with such service; (d) to units which are not installed in accordance with normal
applicable local codes, ordinances and good trade practices; and (e) the unit is used for purposes
9