Operating Guide

5
Outlet
Inlet
1
Outlet Hose
2
Water Source
Outlet Inlet
3 ft. Max.
Vertical
STOP
1
INSTALLATION INSTRUCTIONS
A
B
NOTE: Pump (A) depends on the liquid owing through
it for lubrication. DO NOT RUN THE PUMP (A) DRY!
1. Mount pump (A) solidly on a stable platform. Pump
(A) should be located so that the water source is
within reach of 6 ft. inlet hose (B).
2. Check to be sure there is a washer in the inlet tting
of inlet hose (B). Install inlet hose (B) on the inlet side
of pump (A). Make sure all connections are tight. If
connections leak, pump (A) will not operate.
A
B
1. To prime pump (A), ll the pump cavity through the
outlet to wet the impeller.
PRIMING AND STARTUP
A