Installation Guide

ASSEMBLY INSTRUCTIONS

5. Adjust the three fixture wires to the

desired length

7. Install light bulbs (not included) in accordance with

fixture specifications. Use three 60-watt max.

E12-base bulbs.

DO NOT EXCEED THE MAXIMUM WATTAGE.

To Shorten the Lamp: See illustration #1.

Push each of the three guy wires up into the canopy.

To Lengthen the Lamp: See illustration #2.

Press bushing up and pulleach of the three guy wires

down.

NOTE: The three guy wires and power cord should be

approximate height and power cord is somewhat

loose to prevent the power cord wire load.

6. Pre-install one threaded stem (DD) into the spider arm

of fixture assembly (C) and insert the first hole on the

shade (D), hold the shade (D) in place and install

the other two thread stems (DD) through each hole of

shade (D) into the spider arm.

NOTE: The spider and the beads are attached.

x 3

Threaded Stem

Hardware Used

Bushing

Lowes.com