Operating Guide

OPERATING INSTRUCTIONS

ON/OFF Switch

The on/off switch (E) is at the back of the light. Press the

switch (E) toward the “I” symbol to turn the light on.

Press the switch (E) toward the “O” symbol to turn the

light off.

NOTE: Always turn the work light off before unplugging.

Adjusting the light direction

The lamp head (C) can be adjusted freely to the

desired angle.

With one hand securely holding the folding stand (D),

use the other hand to adjust the lamp head (C).

Extension Cords

- The maximum extension cord length recommended for this work light is 49 in. Use of extension

cords longer than 49 in. may cause a voltage drop that can dim the lights.

- Extension cords used with this work light must have an adequate American Wire Gauge (AWG) or

wire size for safe, efficient use. The smaller the gauge of the wire, the greater the capacity of the

wire (e.g. 14-gauge wire has more capacity than 16-gauge wire).

- Use an extension cord or minimum 14-gauge (AWG) 3-conductor or higher capacity wire, such as

12-gauge or 10-gauge for this work light.

- Always make sure the prongs on the plug of the extension cord are the same number, size and

shape as those on the work light plug.

- Always be sure that the extension cord is in good electrical condition.

Storage

1. Always allow the work light to cool down completely before storing.

2. Store in a safe place, out of reach of children.