Installation Guide

Before beginning installation of product, make sure all parts are present. Compare parts with package

contents list and hardware contents list. If any part is missing or damaged, do not attempt to

assemble, install or operate the product.

Estimated assembly time: 30 minutes

Tools required for assembly (not included): Safety Glasses, Tape Measure, Phillips Screwdriver,

Flathead Screwdriver, Drill, Drill Bit, Ladder, Soft Cloth.

1. Find a suitable location to mount the fixture (A) that will reach

the power supply.

The fixture (A) can be installed

using captive mounting screws

which are preinstalled on the inside of the wire compartment or

installed at the keyhole locations using the provided hardware

kit. To begin first remove the screws from both sides of the

wire compartment cover (B).

Once the screws are removed,

place the cover aside to expose the captive mounting screws

and the keyhole locations. These will be located on both ends

of the wire compartment.

2. EASY INSTALLATION: The fixture can be mounted in two

ways. For installation using pilot holes for the screws, place the

fixture (A) firmly against the mounting surface. While holding in

position, mark the surface for the pilot hole locations by turning

both screws with a phillips head screwdriver until they dimple

the surface. Using a 1/16 in. drill bit, drill the pilot holes for the

screws. Secure the fixture to the cabinet by tightening the

mounting screws into the drilled pilot holes. The fixture can

also be mounted without the use of pilot holes by firmly holding

the fixture against the mounting surface and turning the

mounting screws until the fixture is snug against the surface.

17. You must limit your installation to a total of 60 LED fixtures in any given circuit chain. Installing

more than 60 LED fixtures may overload the connector wiring and result in a hazardous situation.

18. Do not use an extension cord. Use power strip with integral overcurrent protection to supply

power to the fixture.

IMPORTANT: These LED light heads use light emitting diodes to provide light. LEDs are electronic

semiconductors and do not have a filament that can burn out like an ordinary light bulb. As such, the

LED light heads can last up to 50,000 hours when used intermittently, and therefore, never need

replacing.

SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO YOUR LIGHT FIXTURE SO YOU CAN

REFER TO THEM AT A LATER TIME. Before installation, plug in fixture to a 120 V 60 Hz electrical

outlet to check for proper operation. Then, unplug and begin the installation.

IMPORTANT SAFETY INSTRUCTIONS

PREPARATION

INSTALLATION INSTRUCTIONS