Installation Guide

ManualsBrandsUtilitech Pro ManualsLighting & FansDesigner 9.12-in Plug-In Under Cabinet LED Light Bar

ITEM #0378136

MODEL #GU0209CL-BA-I

DESIGNER LED

CABINET LIGHT

Français p. 6

Español p. 11

Questions, problems, missing parts? Contact the customer service department at

1-866-994-4148, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.

ATTACH YOUR RECEIPT HERE

Serial Number: Purchase Date:

Utilitech & UT Design® are registered

Summary of content (5 pages)

PAGE 1
ITEM #0378136 DESIGNER LED CABINET LIGHT Utilitech & UT Design® are registered trademarks of LF, LLC. All Rights Reserved. MODEL #GU0209CL-BA-I Français p. 6 Español p. 11 ATTACH YOUR RECEIPT HERE Serial Number: Purchase Date: Questions, problems, missing parts? Contact the customer service department at 1-866-994-4148, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.
PAGE 2
PACKAGE CONTENTS C A B PART A B C D D DESCRIPTION Fixture Wire Compartment Cover Power Cord Linking Cord QUANTITY 1 1 1 1 HARDWARE CONTENTS (shown actual size) AA Wood Screw Qty. 2 WARNINGS AND CAUTIONS WARNING • Please read and understand this entire manual before attempting to assemble, operate or install the product. CAUTION • This fixture is dimmable with a forward phase electronic dimmer.
PAGE 3
IMPORTANT SAFETY INSTRUCTIONS 17. You must limit your installation to a total of 60 LED fixtures in any given circuit chain. Installing more than 60 LED fixtures may overload the connector wiring and result in a hazardous situation. 18. Do not use an extension cord. Use power strip with integral overcurrent protection to supply power to the fixture. IMPORTANT: These LED light heads use light emitting diodes to provide light.
PAGE 4
INSTALLATION INSTRUCTIONS 3. KEYHOLE INSTALLATION: Position the fixture (A) and mark the location of the narrow ends of the keyhole slots onto the mounting surface. Drill a 1/16 in. pilot hole into the marked screw locations. You can also use an awl or nail to dimple the screw holes. While holding the fixture in place tighten the wood screws (AA) with a phillips head screwdriver until the fixture is flush with the surface. 3 Hardware Used AA A AA Wood Screw x2 4.
PAGE 5
LINKING INSTRUCTIONS 3. Each additional fixture (not included) should be mounted in the same way as the first installed fixture (A). After each additional fixture is installed, connect to the adjacent fixture by following the linking instructions outlined in steps 1 and 2. Make sure the power is off before connecting additional fixtures. Also, make sure the distance between fixtures does not exceed the connector cord (D) length.