Use and Care Guide

5. Make sure wire connections are secure. Carefully place wires

into junction box. Position the light fixture (A) cover plate over

the crossbar.

Note: Put the long mounting screw through the center hole and

into the crossbar and tighten the screw until secure. Insert

mounting screw cap (CC) into mounting screw hole. DO NOT

overtighten.

IMPORTANT: After mounting thefixture light, apply silicone caulking compound completely

around the perimeter of the cover plate where the back of the cover plate meets the mounting

surface. Silicone caulking prevents water from seeping into the junction box.

CAUTION: Ensure fixture is mounted as indicated by icon in lamp base. Do not mount

UPSIDE DOWN! Failure to do so could affect product performance.

Your installation is now complete. Turn on power at circuit breaker and flip wall switch to ON

position.

Hardware Used

Mounting screw cap x 1