Installation Guide

Pump must be installed in a suitable
gas tight, properly vented basin that
is at least 24 inches deep and 11 inches
wide for pumps fitted with vertical
on/off switches.
Pump must be placed on a hard
surface in a sump that has been cleared
of all debris. Never place the pump on
clay, earth or gravel surfaces.
Pump will automatically activate with
8.2 inches of water in basin.
Pump will turn off when water level
reaches 4.6 inches.
Plug into GFCI protected electrical
outlet.
Connect the discharge pipe, fittings and
check valve to the discharge port of
the pump. It is recommended that the
discharge pipe diameter should be
equal to or larger than the discharge
size of pump.
Pump must be installed in a suitable
basin that
and 11 inches
with vertical
on/off switches.
Pump must be placed on a hard
surface in a sump that has been cleared
of all debris. Never place the pump on
clay, earth or gravel surfaces.
Pump will automatically activate with
710 inches of water in basin.
Pump will turn off when water level
reaches 25 inches.
Plug into GFCI protected electrical
outlet.
Connect the discharge pipe, fittings and
check valve to the discharge port of
the pump. It is recommended that the
discharge pipe diameter should be
equal to or larger than the discharge
size of pump.
STEP1
STEP2
STEP3
STEP4
STEP6
STEP5
is at least 24 inches deep
wide for pumps fitted