Operating Instructions
18 19
L. Care and Maintenance
1. Take care not to drop or knock the scope once it is zeroed.
2. Keep the protective lens covers in place when the scope is not being used.
3. Maintain the metal surface of the scope by removing any dirt or sand with a soft brush so as to
avoid scratching the nish.
4. Wipe the lens with a clean annel cloth to keep it clean and dry. In order to avoid scratching
the glass, ensure both the lens and cloth are clean. Do not use nger or nger nail to touch/
clean lenses.
5. Store the scope in a cool dry place when not in use. Be careful to avoid contact with acid,
alkaline or corrosive chemicals.
6. Do not attempt to lubricate any part of the scope.
7. Do not disassemble the scope. Do not loosen or remove screws or parts. Any such or similar
actions will void the warranty.
Caution: Viewing the sun can cause serious eye injury. Never look directly into the sun with this or
any scope.
M. Limited Lifetime Manufacturer’s Warranty
Warranty against material or workmanship defects applies based on the following conditions -
• Scope was purchased new. Evidence of purchase is required for warranty service.
• Scope was not disassembled, parts / screws not removed or loosened, and the scope was
not tampered with in any way. Any evidence of such interference will void the warranty.
• Scope has not been abused, maliciously damaged or treated in a manner not in keeping
with the purpose it was designed for.
For warranty service, please contact the scope distributor and provide a written problem description to
obtain a Return Authorization Number before returning the product for repair or replacement.
K. installing Sunshade (For Models with
Detachable Sunshade Only)
1. Unscrew the Objective Lens Protective Ring off the objective
(Not all model come with a Objective Lens Protective Ring).
2. Screw on a compatible sunshade to the front of the objective.
Make sure it is tightened and fully secured.
3. Screw the Objective Lens Protective Ring onto the front of
sunshade(Optional).
Note: