Operating Instructions

8 9
c. Mounting the Scope Ring
CAUTION: Make sure rearm is not loaded. Remove magazine (if
applicable) and examine chamber. Use safe handling procedures at all times.
C-1. QD Lever Lock Scope Rings C-2. Twist Lock Scope Rings
C-3. Thumb Nut Locking Scope Rings
C-4. Hex Screw Locking Scope Rings
C-1. Mounting QD Lever Lock Scope Rings
1. Turn the Cam Lever in the
direction that widens the
spring loaded locking plate and
provides the needed mounting
clearance for installation. Make
sure the QD mount base’s cross
bolt seats properly within the
Picatinny slot.
2. Turn the Cam Lever in the
opposite direction to close the
spring loaded locking plate,
locking the QD mount base to
the Picatinny rail.
3. Should the QD mount base be
loose, unlock the Cam Lever and
use the included Allen Wrench to
adjust the Hex Screw found within
the Cam Lever Housing. Turning
the Hex Screw clockwise will
increase the locking plate tension
by decreasing the clamping width.
4. Should the Cam Lever not fully
turn into the locked position
and you feel heavy resistance,
the locking plate tension is too
high. Use the included Allen
wrench to adjust the Hex Screw
counterclockwise to decrease
the locking plate tension by
increasing the clamping width.
5. The optimal tension is
achieved when the locking
plate rst makes contact with
the Picatinny rail while the
Cam Lever still has enough
travel left for you to turn the
Cam Lever to the locked
position.
1
1. Turn the Hex Screws counterclockwise with the included Allen
wrench to widen the locking plate and provide the needed mounting
clearance to evenly seat onto the Dovetail Rail.
2. If applicable, seat the rings in a position along the rail where the
ring’s Stop Pin can fully seat and make contact with one of the
Dovetail rail’s recessed stop pin holes.
3. Once seated, turn the Hex Screws clockwise using the included
tool to tighten locking plate and secure the scope ring to the
Dovetail rail. Do not exceed 30 inch-pounds.
C-4. Mounting Hex Screw locking Scope Rings
Stop Pin
Locking Holes
1. Turn the Twist Lock or Thumb Nut counterclockwise to widen the
locking plate and provide the needed mounting clearance to evenly
seat onto the Picatinny Rail.
2. Once seated, turn the Twist Lock or Thumb Nut clockwise to tighten
the locking plate and secure the scope ring to the Picatinny rail. Do
not exceed 30 inch-pounds.
C-2., C-3. Mounting Twist Lock and Thumb Nut
Locking Scope Rings
D. Installing the Scope
(ring style in the following images is for illustration purposes only.
Your specic style may vary)
1. Using the included Allen wrench, turn the screws
counterclockwise to completely remove the top half of the rings.
2. Place the scope within the scope ring bases, taking care
to properly adjust for a comfortable eye relief and that the
scope’s reticle is leveled.