LEAPERS , INC. ® OPTICS Complete Installation and Operating Instructions w w w. l e a p e r s .
Leapers Inc. ® Proudly Presents UTG OPTICS RANGE ESTIMATING SCOPES RETICLE INTENSIFIED SCOPES TOTAL SOLUTION TO YOUR NEEDS -COMMITMENT TO BEST QUALITY, BEST VALUE AND BEST SERVICEwww.LEAPERS.com 32700 Capitol Street, Livonia, MI 48150, U.S.A. Tel:(734)542-1500 Fax:(734)542-7095 Email:office@leapers.com Index A. Scope Parts Illustration 4 B. Major Features 7 C. Mounting the Scope 8 D. Understanding the Reticle 10 E. Adjusting Diopter 12 F. Installing Battery 12 G.
4 5 a. scope parts illustration PARTS LIST ! WARNING: Read entire manual before 11 01 mounting your scope. Make sure the firearm is not loaded upon installation. 02 G R 03 04 01. Eyepiece Assembly 02. EZ-TAP Control Panel (For Reticle Illuminated Scopes with IE Capability) 03. Power Ring (For Variable Power Scopes Only) 04. Windage Adjustment Knob 05. Elevation Adjustment Knob 06. Adjustment Hex Screw (Optional) 07. Zero Locking Ring (Optional) 08.
6 7 b. Major Features ACCESSORIES ► Built on True Strength Platform, Completely Sealed and Nitrogen Filled, Shockproof, Fogproof and Rainproof Optional - 3” Sunshade (for 50mm Obj. Dia. Scope) • Rugged one piece tube construction for all terrains/weather. Optional - 2.5” Sunshade (for 40mm Obj. Dia. Scope) • Smart spherical structure (SSS) to achieve the most responsive, precise and reliable windage and elevation adjustment.
8 c. Mounting the Scope 1 5 CAUTION: Always ensure your rifle is UNLOADED, UNCOCKED and, where applicable, the safety catch is applied before fitting the scope. Practice safe handling procedures at all times. 6 7 3 7 2 8 4 Replace the top ring halves and tighten the screws evenly by the Cross-torque Pattern. Do not over-tighten the screws as damage to scope tube may occur.
10 d. understanding the reticle 1. Each scope has a reticle for aiming. A reticle is a thin planar component disposed perpendicular to the optical axis inside the main tube. It is made by etched metal film or etched glass. The former is called Wire Reticle, and the latter is called Etched Glass Reticle. 11 MIL-DOT RETICLE Mil-dot reticle is the most widely used reticle on Leapers riflescopes which provides range estimating capability.
12 13 Color Index Table G Button IE Diopter adjustment provides additional focus adjustment to adapt the scope to your eyesight. FULL Diopter adjustment ring is located at the ocular end of the scope. Aim the scope at your target, hold still and turn the dial ring clockwise or counter-clockwise until both the crosshair and the target are in the sharpest focus. 36 COLORS Color 1. R Button e.
14 15 J. Zeroing iv. The purpose of zeroing the scope is to ensure that the scope is aligned with the impact point of the pellet or bullet from the rifle. Before zeroing the scope, read the following adjustment knob instructions carefully. Having adjusted the windage and elevation as required, fire, if safe to do so, another test shot. Keep adjusting and test firing until the test shot impacts on the center of the target when the reticle is on the center of the target.
16 ii. J-6 Lockable W/E Operation Zeroing on the Target 1. a. Place a target 100 yards away (35 yards for air gun). b. Ideally, use a steadying device such as a shooting stand or bipod, set the scope at highest magnification, aim at the center of the target, fire a test shot, if safe to do so. c. d. e. WARNING: Vertical adjustment (Elevation) – Use your fingers to turn the adjusting knob as required.
18 19 K. installing Sunshade (For Models with Detachable Sunshade Only) 1. Unscrew the Objective Lens Protective Ring off the objective (Not all model come with a Objective Lens Protective Ring). 2. Screw on a compatible sunshade to the front of the objective. Make sure it is tightened and fully secured. 3. Screw the Objective Lens Protective Ring onto the front of sunshade(Optional). L. Care and Maintenance 1. Take care not to drop or knock the scope once it is zeroed. 2.
20 e r o l Exp e r o M At ered adquart Inc., he , rs been e p s Lea .A., ha an, U.S ig lying h p ic p in M s of su s e in s u utdoor in the b g and o n ti n u h g, set unshootin 91. We 9 1 e r c ards fo gear sin h stand ig h . d s e mis eration compro ess op in s u b ta ur a to l all of o provide to is l ts a produc Our go line of y n a n r o n fo attenti solutio y close a p r e e r.
