User's Manual
Table Of Contents
- Product overview
- Installation environment
- Package contents
- Camera description – Bullet Camera
- Camera description – Desktop Camera
- Accessing the Micro SD card
- Mounting
- Browser requirements
- Quick setup
- Alternative methods of adding cameras
- UltraSync app basic functions
- Change default camera settings
- Reset cameras to factory default
- Troubleshooting
- Specifications
10. Change LAN settings to the required configuration. If a static
IP Address is required, change the IPv4 Address and IPv4
Subnet Mask to match the router.
a. Change the static IP address to something different than
the default 192.168.1.70 if more than one camera is used
on the network.
b. Click the Test button to ensure that the IP address is not
already assigned to another device in the network.
11. Click Save on the bottom of the screen.
12. Power cycle the camera. See “4. Reboot cameras” on page
18.
Add cameras via WPS
A WPS-enabled wireless router is required to add a camera using
the WPS function.
1. Press the WPS button on the router.
2. Within 120 seconds of pressing the WPS button on the router,
press the WPS button on the camera for approximately two
seconds. See “Camera description – Bullet Camera” on page
6 and “Camera description – Desktop Camera” on page 7 for
WPS button and LED locations.
The link LED on the camera flashes rapidly to indicate that it
has joined the wireless network.
3. Power cycle the camera. See “4. Reboot cameras” on page
18.
P/N 466-5303 • REV 07 • ISS 05JAN17 © 2017 United Technologies Corporation. All rights reserved 19