User's Manual

Table Of Contents

Note: The camera may take up to two minutes to finalize

association with the intrusion panel and appear in the cameras

tab.

4. Reboot cameras

1. Launch the TruVision

IP camera configuration browser.

2. Select System and then select Maintenance on the left menu.

3. Select Reboot.

4. Select OK when asked if you want to reboot the unit.

Note: Reboot may take up to two minutes.

5. Go to the Cameras tab in the UltraSync app to verify live

video.

Camera installation is now complete!

Alternative methods of adding cameras

Add cameras via Ethernet with a Windows PC

1. Apply power to the camera using the included power supply.

Note: It may take up to two minutes for the camera to boot up.

2. Connect the camera to a router with an Ethernet cable.

3. Launch TruVision Device Manager.

Note: Install TruVision Device Manager using the included CD

or download it from www.interlogix.com/video.

4. Verify that the camera is found in the main camera selection

window.

5. Select the camera to be configured.

6. In the Password field, type the default password of 1234 and

click Save.

7. In the main camera selection window, select the camera you

would like to configure and double click the IPV4 Address to

launch TruVision IP Camera Configurator in a browser.

Note: The Camera Configurator can also be launched by

typing the camera’s IP address into an internet browser. The

default camera IP address is 192.168.1.70 in a network

without a DHCP server.

8. The TruVision Configurator appears. Enter the credentials

below:

 User Name: admin

 Password: 1234

9. Tap Network and then tap Basic Settings on the left menu.