User's Manual

Table Of Contents

3. Add cameras to UltraSync

Ensure the proper installation of camera hardware and follow the

instructions in “Add cameras to a Wi-Fi network” on page 15

before adding cameras to UltraSync.

Note: Make sure the camera and UltraSync intrusion panel are on

the same local area network. Applications where the intrusion

panels use cellular only (no Wi-Fi or Ethernet connection) are not

compatible with this camera.

Note: For detailed information on how to set up the UltraSync

app, add locations, and log in as an installer, see the UltraSync

Hub Reference Guide.

1. Using an iOS or Android device, open the UltraSync app and

2. Tap the menu icon at the top left of the screen, and then tap

Settings.

3. Tap Cameras in the Settings Selector drop-down.

4. Tap Scan for New Cameras.

5. The “Success!” message appears after a few seconds.

Note: The “Success" message appears after a camera scan

was executed. This does not indicate cameras were added to

the system.

6. The IP and MAC addresses automatically populate for all

cameras on the network. Scroll down to see and verify

connected cameras.

7. Tap Save.