User's Manual

Table Of Contents

75-85 – Very Good:

No additional actions are required to increase signal strength. It is

not recommended to increase video resolution settings.

65-75 – Good:

We recommend using a Wi-Fi repeater or powerline adapter to

increase signal strength. Alternatively, video resolutions settings

may be reduced to minimize poor video quality.

Below 65 – Poor:

We do not recommend using a camera with a signal strength

below 65. Video streams are not likely to work below this level. A

Wi-Fi repeater or powerline adapter should be used to increase

signal strength.

2. Add cameras to a Wi-Fi network

RECOMMENDED METHOD

(use a temporary Wi-Fi connection for setup)

Note: We highly recommended using a dedicated router for all

UltraSync installations that include cameras for the following

reasons:

 Avoids service calls from homeowners as a result of changing

their Wi-Fi password.

 Maintains privacy of the homeowner’s Wi-Fi network

password.

 Reduces the risk of local communication issues between the

router, cameras, and UltraSync panels.

Note: While the steps below are followed, the camera cannot be

accessed by users other than the user performing the setup.

1. Apply power to the camera using the included power supply.

Note: It may take up to two minutes for the camera to boot up.

2. Note the model and serial numbers on the camera.

3. Find the camera in the list of wireless networks available to the

device being used for setup and initiate connection.

4. Enter the camera’s serial number as the security

key/password.

5. Log in to the browser interface (see “Browser requirements”

on page 13) using the default settings: