User Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Planning
- Chapter 3 Installing the system
- UL listed installations
- SIA system requirements
- Central station reporting
- UL Canada listed installations
- California state fire marshall listed installations
- Opening panel cover and chassis
- Mounting the panel
- Connecting hardwired devices
- Wiring a phone line to the panel
- Wiring the power transformer
- Installing X10 modules
- Chapter 4 Programming
- Programming overview
- Menu navigation
- System programming
- Resetting memory to the factory defaults
- Chapter 5 Testing
- Chapter 6 Troubleshooting and support
- Appendix A Specifications and tables
- Index
Simon XT
Installation Manual
64
Central station communication
After performing sensor and communication tests, check that the system is reporting alarms successfully to the
central station. Table 33 provides a list of sensor/user report codes.
To test communication with the central station:
1. Call the central station and tell the operator that you will be testing the system.
2. Arm the system.
3. Test each of the wireless panic buttons and trip at least one sensor of each type (fire, intrusion, etc.) to
verify that the appropriate alarms are working correctly.
4. When you finish testing the system, call the central station to verify that the alarms were received.
Table 33. Sensor/user report codes
Arm or disarm from Reports as user
Panel or remote handheld touchpad 0
Keyfob 1 to 40 (sensor number)
Panel aux panic 41
Panel tamper 42
Panel police panic 43
Panel fire panic 44
Dealer access code 44
Installer access code 45
Master code 46
Access codes 1 to 8 47 to 54
Duress code 55