User Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Planning
- Chapter 3 Installing the system
- UL listed installations
- SIA system requirements
- Central station reporting
- UL Canada listed installations
- California state fire marshall listed installations
- Opening panel cover and chassis
- Mounting the panel
- Connecting hardwired devices
- Wiring a phone line to the panel
- Wiring the power transformer
- Installing X10 modules
- Chapter 4 Programming
- Programming overview
- Menu navigation
- System programming
- Resetting memory to the factory defaults
- Chapter 5 Testing
- Chapter 6 Troubleshooting and support
- Appendix A Specifications and tables
- Index
Simon XT
Installation Manual
56
Note: You can also program a keyfob button to control a light or appliance module.
To program a light schedule:
1. Press the scroll buttons until the panel displays System programming.
2. Press Enter. The panel displays Enter code.
3. Enter your access code and press Enter. The panel displays Access codes.
4. Press the scroll buttons until the panel displays Light control.
5. Press Enter. The panel displays Set entry lights.
6. Press the scroll buttons until the panel displays Set entry lights.
7. Press Enter.
8. Press the scroll buttons until the panel displays Light schedules.
9. Press Enter. The panel displays Light schedule 1 <--:-- - --:-->.
10. Press the scroll buttons until the panel displays the unit number you want to program.
11. Press Enter. The HH of the start time will flash.
12. Press the scroll buttons to set the hours.
13. Press Enter. The MM of the start time will flash.
14. Press the scroll buttons to set the minutes.
15. Press Enter. The AM/PM of the start time will flash.
16. Press the scroll buttons to set the AM/PM setting.
17. Press Enter. The end time starts to flash.
18. Follow the same instructions to set the hour, minute, and AM/PM settings for the end time.
19. Press STATUS repeatedly to exit.
Lock interval
Note: This feature has not been investigated for use by UL.
Sets the start and stop times that determine when the panel prevents the sensor-activated lights feature from
turning on sensor-activated lights.
Note: System time must be set correctly for this feature to work.
When a time value is set (on) and the sensor-activated lights feature is on, the panel prevents sensor-activated
lights from turning on between the programmed start time (this option) and the programmed stop time.
Note: Both sensor-activated light lockout start time and sensor-activated light lockout stop time must have a time programmed
for this feature to work correctly.