User Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Planning
- Chapter 3 Installing the system
- UL listed installations
- SIA system requirements
- Central station reporting
- UL Canada listed installations
- California state fire marshall listed installations
- Opening panel cover and chassis
- Mounting the panel
- Connecting hardwired devices
- Wiring a phone line to the panel
- Wiring the power transformer
- Installing X10 modules
- Chapter 4 Programming
- Programming overview
- Menu navigation
- System programming
- Resetting memory to the factory defaults
- Chapter 5 Testing
- Chapter 6 Troubleshooting and support
- Appendix A Specifications and tables
- Index
Simon XT
Installation Manual
46
6. Press Enter. The panel displays Trip sensor ##, with the number signs flashing.
Note: If you wish to use a sensor number other than the next one available, use the number keys to enter a two-digit
sensor number immediately.
7. Press the sensor program button or release the sensor tamper switch. The panel displays Sn ## Grp 10
<Front Door>, with the Grp 10 flashing. Use the number or scroll buttons if you want to enter a new
group number; press Enter to accept the group number displayed.
8. The sensor text is now flashing. Use the scroll buttons to scroll through the text list or enter the three-
digit shortcut. (See Tab le 3 8 on page 72 and Table 39 on page 73 for these three-digit codes). Press
Enter to accept the first text segment. You may enter more text or press Enter again to finish adding
the sensor.
9. The panel displays Trip sensor ## (with the next available sensor number). Press STATUS repeatedly
to exit.
Deleting sensors
To delete a sensor:
1. Press the scroll buttons until the panel displays System programming.
2. Press Enter. The panel displays Enter code.
3. Enter your access code and press Enter. The panel displays Access codes.
4. Press the scroll buttons until the panel displays Sensors.
5. Press Enter. The panel displays Learn sensor.
6. Press the scroll buttons until the panel displays Delete sensor.
7. Press Enter. The panel displays Sn ## Grp ## <Text>.
8. Press the scroll buttons until the panel displays the sensor you want to delete.
9. Press Enter. The panel displays Deleted, then shows Delete sensor.
10. Press STATUS twice to exit.
Editing sensors
You can use this feature to change the group or name of a sensor that is already in panel memory. The
procedure is very similar to the procedure used to program sensor information after a sensor is learned in.
Pressing DISARM while editing sensor text deletes all text for that sensor.
Table 17. Sensors
Function Default Description
Learn sensors Adds (learns) sensors to panel memory.
Delete sensors Deletes sensors from panel memory.
Edit sensors Edits sensor information in panel memory.