Owner's Manual

23
Programming
To program Call Waiting, press:
Add—Option #—56—Up to 26 digits—DONE.
Note
Pressing DONE is required if you enter fewer than 26
digits. The phone number is automatically stored without
pressing DONE if all 26 places are used.
To delete Call Waiting, press:
Delete—Option #—56—DONE.
Option 57: Supervisory/Tamper Report
(Default = off)
Determines whether the panel sends supervisory reports to a
central station as a tamper (on) or a supervisory (off).
Note
This option is typically used only in Europe where a
supervisory condition is required to report as a tamper.
To report supervisories as Tamper Reports, press:
Add—Option #—57—DONE.
To report supervisories as Supervisory Reports, press:
Delete—Option #—57—DONE.
Option 58: Remote Touchpad Arming
(Default = off)
Determines whether keychain and remote touchpads can dis-
arm the system only during exit and entry delays (on), or arm
and disarm the system anytime (off).
CAUTION!
If this option and Option 28: No Delay from Keychain
Touchpad is on, users cannot enter and/or disarm
using remote touchpads without causing an alarm.
To turn on Remote Touchpad Arming, press:
Add—Option #—58—DONE.
To turn off Remote Touchpad Arming, press:
Delete—Option #—58—DONE.
Option 59: Exit Extension (Default = on)
Determines whether the panel restarts the exit delay time if the
user enters the armed premises during the initial exit delay
period (on), or not (off).
Turning on this feature allows users to re-enter during the exit
delay period, without disarming and then re-arming the system.
Turning off this feature requires the user to disarm and re-arm
the system.
Note
For UL listed systems, Exit Extension must be off.
To turn on Exit Extension, press:
Add—Option #—59—DONE.
To turn off Exit Extension, press:
Delete—Option #—59—DONE.
Option 60: Secure Arming (Default = off)
Determines whether an access code is required when arming
the system (on) or not (off).
This option does not affect keychain touchpad arm/disarm
operation.
To turn on Secure Arming, press:
Add—Option #—60—DONE.
To turn off Secure Arming, press:
Delete—Option #—60—DONE.
Option 61: Demo Mode (Default = off)
Determines whether the panel operates as a demonstration
model (on) or a standard panel (off).
Turning on this feature disables low battery supervision and
allows the microphone to remain on continuously during an
AVM session.
To turn on Demo Mode, press:
Add—Option #—61—DONE.
To turn off Demo Mode, press:
Delete—Option #—61—DONE.
Option 62: Supervisory Protest (Default = off)
Determines whether the panel protests arming if it has not
received a supervisory signal from any sensor 15 minutes
before arming (on) or not (off).
Note
This feature must be turned on for European installa-
tions, but turned off for U.S. installations.
To turn on Supervisory Protest, press:
Add—Option #—62—DONE.
To turn off Supervisory Protest, press:
Delete—Option #—62—DONE.
Option 63: 24 Hour Time (Default = off)
Determines whether the panel uses a 24-hour clock (on) or 12-
hour clock (off).
To turn on 24 Hour Time, press:
Add—Option #—63—DONE.
To turn off 24 Hour Time, press:
Delete—Option #—63—DONE.