Owner's Manual

8
Installing the System
Full Line Seizure Wiring with an RJ-31X
Note
For UL Listed systems, the RJ-31X jack must be
mounted within 5 feet of the panel.
1. Run a 4-conductor cable from the TELCO block to the
RJ-31X (A in Figure 8).
2. Connect the 4-conductor cable wires to the RJ-31X (B
in Figure 8).
3. Disconnect the Green and Red premises phone jack
wires from the TELCO block and splice them to the 4-
conductor cable Black and White (or Yellow) wires (C
in Figure 8). Use weatherproof wire connectors for
these splices.
4. Connect the 4-conductor cable Green and Red wires to
the TELCO block TIP (+) and Red to RING (-) posts
(D in Figure 8).
5. Connect the phone cord included with the panel to the
RJ-31X and the panel LINE IN jack (E in Figure 8).
Figure 8. Full Line Seizure Wiring with an RJ-31X
Full Line Seizure Wiring with 1 Premises Phone
If a single phone is all that exists on the premises, full line sei-
zure can be accomplished without an RJ-31X.
Note
If the customer ever adds a phone or other phone device
to another phone jack, full line seizure no longer exists.
Inform the customer to contact you if they want to add a
phone or other device so that you can rewire for full line
seizure by adding an RJ-31X.
1. Disconnect the phone from the premises phone jack
and plug it into the panel PHONE jack (A in Figure 9).
This jack is disconnected automatically whenever the
panel reports.
2. Connect the phone cord included with the panel to the
panel LINE IN jack and the premises phone jack (B in
Figure 9).
Figure 9. Full Line Seizure Wiring with 1 Premises
Phone
No Line Seizure
This method is typically used where DSL (digital subscriber
line) service exists. DSL allows multiple devices on a single
phone line to be used simultaneously. Simply connecting the
panel LINE IN jack to an available phone jack on the premises
is all that is required.
An in-line filter may be required to ensure panel reporting is
successful.
Note
Connecting the panel to a standard phone (voice) line in
this manner should be avoided. Other devices in use at
the same time the panel is using the line can prevent
reports from going through.
H W I N 1
H W I N 2
E
A
B
C
D
Premises
Phone Jack
Wires
TIP
(+)
RING
(-)
BRN
GRN
RED
Black
Green
Red
GRY
Red
Green
Red
Green
Black
White (or Yellow)
(or Yellow)
White
H W I N 1
H W I N 2
A
B
Premises
Phone Jack
Lone Premises Phone