Install Manual
Table Of Contents
- Dialog Telephone Interface Module
- Product Summary
- Installation
- Installation Guidelines
- Programming-Adding the DTIM to Panel Memory
- 1. Remove the DTIM cover and install the antennas (see Figure 1).
- 2. With the system disarmed, enter program mode at the Allegro panel by pressing 8 + CODE.
- 3. Press twice and É twice. The Allegro display shows zone 01 - trip.
- 4. Locate the DTIM tamper switch and LED (see Figure 2 at left).
- 5. Press and release the DTIM tamper switch as follows:
- 6. Exit from program mode.
- Testing DTIM Transmitting Range
- 1. Place the DTIM in the desired location.
- 2. Put the Allegro panel into sensor test mode. The panel piezo should sound 7 - 8 beeps. This indicates good reception from the DTIM to the panel.
- 3. If you hear fewer than 7 beeps, test the DTIM in different locations. Mounting locations should be limited to areas where the panel responds with 7 - 8 beeps.
- 4. To retest transmitting range after relocating the DTIM, press Ç then É at the Allegro panel and listen for 7 - 8 beeps.
- 5. Exit from test mode after determining acceptable locations.
- Mounting
- Wiring a Phone Line to the Module
- 1. Run a 4-conductor cable from the TELCO block to the RJ-31X (A in Figure 4).
- 2. Connect the 4-conductor cable wires to the RJ-31X (B in Figure 4).
- 3. Disconnect the Green and Red premises phone jack wires from the TELCO block and splice them to the 4-conductor cable Black and White (or Yellow) wires (C in Figure 4). Use weath erproof wire connectors for these splices.
- 4. Connect the 4-conductor cable Green and Red wires to the TELCO block TIP (+) and Red to RING (-) posts (D in Figure 4).
- 5. Insert the 8-conductor phone cord plug into the RJ-31X jack (E in Figure 4).
- 6. Remove the right knockout on the DTIM plastic, feed the 4-conductor phone cord plug through it and connect the plug into the DTIM phone jack (Figure 5 at right).
- Phone Test
- 1. Call the central monitoring station to inform them you are testing the system.
- 2. Make sure the panel has the correct account number and central station receiver phone num ber programmed.
- 3. Enter the appropriate phone test command for the panel used in the system.
- 4. Contact the central monitoring station when you are finished testing.
- Installing the Battery Ty-wrap and Cover Screw (UL Listed Installations Only)
- Trouble- shooting
- Specifications
- Notices
