TX-2810-01-4 Wireless Outdoor PIR 319.5MHz Detector Installation Sheet EN DE ES FR IT NL PL PT SV 1 2 3 4 5 6 © 2012 UTC Fire & Security. All rights reserved. 1/7 P/1 REV 2.
7 8 9 10 11 12 13 14 0 0 2/7 1.5 5 3 10 4.5 15 6 20 7.5 25 9 30 10m 33ft. P/1 REV 2.
15 16 17 1 2 EN: Installation Sheet Package The package contains: 1 x Wireless Detector 1 x drilling template for fixing holes 2 x 3V Lithium CR123 batteries 2 x 31.75 mm / 1.25 in. wall plugs 2 x 31.75 mm / 1.25 in. screws 1 x lens mask 2 x additional curtain shutters 1 x tamper cup 2 x tamper caps (different lengths) 1 x plastic locking tool 1 x installation sheet 1 x front cover screw cap Introduction The Wireless Outdoor PIR 319.
will require the detection subject to move further through the already reduced detection area before an activation is signalled. Both sensors must trigger to cause the detector to signal an alarm. The Detector uses quad PIR technology to deliver precise, reliable presence detection. Programmable options include a variable pulse count and a choice of three detection ranges: 10 m / 33 ft., 20 m / 66 ft., and 30 m / 98 ft. The integral dual-axis tilt sensor allows 180° of pan and 90° of tilt.
Note: PIR sensor is more sensitive to a movement across the beams, and less sensitive to a movement directly towards or away from the beams. The detector module is fitted with two sliding shutters to reduce the detection angle. The curtains are fitted to the pan and tilt module as shown in Figure 6. Each section of the detector lens gives a coverage pattern of approximately 10 degrees. An additional set of curtain sliders is provided should the beam pattern be narrowed even further, e.g.
To change any settings: 1. Press the programming button to select the option number you want to change. Press once for range, twice for pulse count, and three times for detection LED. 2. Wait until the programming LED turns off (typically 4 seconds). 3. Count the number of times the programming LED flashes to determine the current value for that option. 4. Press the programming button to select the value number for the new setting. Example: To set the range to 30 m / 98 ft., press three times.
Regulatory information Manufacturer Authorized EU manufacturing representative: UTC Fire & Security B.V. Kelvinstraat 7, 6003 DH Weert, Netherlands Certification EN EN 50130-5, Grade 2, Class IV Environmental class IP65 FCC compliance This device complies with part 15 of the FCC Rules.
