User's Manual
Table Of Contents
- Product Summary
- Tools Needed
- Installation Guidelines
- Installation
- 1. Decide if the sensor should be mounted horizontally or vertically by locating the alignment ma...
- 2. Remove the sensor cover by squeezing the cover ends firmly to release the tab on the cover fro...
- 3. Remove the circuit board from the sensor base by pulling back the plastic tab and lifting the ...
- 4. Remove the unused reed switch, clipping the leads as close to the board as possible (see Figur...
- 5. Mount the sensor base with screws or brads. Use spacers to compensate for metal surfaces or he...
- 6. Remove the magnet from its base. Mount the magnet base no more than 3/8 inches away from the s...
- 7. Reattach the circuit board to the sensor base.
- 8. Reattach the sensor cover to the sensor base.
- Connecting External Switches
- Programming
- 1. Set the panel to the program mode.
- 2. Proceed to the LEARN SENSORS menu.
- 3. Select the appropriate sensor group and sensor number assignments.
- 4. Set the external switch (if one is connected) in the alarm condition (open for normally closed...
- 5. Trip the sensor’s tamper switch by removing the sensor cover.
- 6. Exit program mode.
- 7. Place the cover back on the sensor.
- Testing
- Specifications
- Notices
- Door/Window & Long Life Door/Window Sensors
