User's Manual
Table Of Contents
- Product Summary
- The SX-V to Learn Mode Translator receives RF signals from SX-V sensors and converts them to Lear...
- Tools and Equipment Needed
- Installation
- Installation Guidelines
- Mounting the Translator
- Wiring the Translator
- 1. Run a 2-conductor, 22-gauge or larger stranded wire cable from the control panel or power supp...
- 2. At the translator, connect the red wire to the +12V terminal and the black wire to the GND ter...
- 3. Make sure the power source (control panel or separate power supply) is powered down.
- 4. Connect the red and black wires to the +12 and GND (-) terminals of the power source.
- Setting the Translator House Code
- Power Up
- Programming
- Adding the Translator to the Panel
- Adding SX-V Sensors to the Panel
- 1. Set the control panel to program mode.
- 2. Select the desired sensor number and sensor group when prompted by the panel.
- 3. When prompted by the panel to trip the sensor, press and release the sensor tamper switch, tes...
- 4. Repeat steps 2 and 3 for all sensors/touchpads.
- 5. Exit from program mode.
- Testing
- Specifications
- Notices
